If you use MEGACABLE, or any other high quality, low gauge speaker wire, the terminals will be too small to accommodate the wires. You need two pairs of speaker pins (available at your local RadioShack store) to make the connection. Follow these steps to connect the wires to each terminal using speaker pins.
1.Separate the conductors for a length of about 2 inches on the end of each wire. Then strip 1/2 inch of insulation from the ends of each conductor and twist the wire ends.
2.Position each wire end between the open barrel ends of a speaker pin.
To
From Left or Right Speaker
3.Using a pair of pliers, crimp down the open barrel ends of the speaker pin to hold the wire end in place.
4.Plug the speaker pin into the proper
HIGH LEVEL OUTPUT terminal on the
CONNECTING TO POWER
HIGH LEVEL INPUT |
|
|
|
| |
R | L |
|
|
|
|
| LOW LEVEL |
|
|
|
|
+ | INPUT | VOLUME | FREQUENCY | ||
L | CONTROL |
| HZ | ||
| R |
|
|
| POWER |
|
| MIN | MAX | 50 | 200 |
POWER
Indicator
|
|
|
| AC120V |
P/NO | WF – 60R | U | LISTED 1Z45 | 60Hz |
EQUIPMENT | ||||
|
| ® L | AUDIO |
|
120V ~ 60Hz | 60W E158878 |
|
| |
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC |
| |||
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE |
| |||
| CAUTION |
|
| |
RISK OF ELECTRIC SHOCK |
|
| ||
| DO NOT OPEN |
|
|
|
WARNING: SHOCK HAZARD - DO NOT OPEN. |
|
| ||
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVREI |
| |||
NOT SUITABLE FOR
Plug the
ADJUSTING THE VOLUME
Once you have made all connections, follow these steps to adjust the
1.Rotate VOLUME CONTROL to MIN.
2.Turn on your amplifier/receiver and another component (such as a radio, cassette player, CD player, or turntable).
3.Begin play of an audio source (such as a radio) and adjust the amplifier/ speaker’s overall volume to a comfortable level. Rotate VOLUME CONTROL clockwise, a little at a time, until you achieve a pleasing balance of bass between the
5
