Getting Started

Connecting the Antenna to Your TV

CAUTION!

Be very careful when you’re connecting the antenna to the power injector and to your TV—you might damage your TV if you install the power injector backwards! Make sure you pay close attention to the jack you use when connecting to the power injector.

To connect the antenna to your TV, follow these steps:

Out to

TV

TINU ANNTENA OT

Out to

ANT

1.Connect the coax downlead from the antenna to the TO ANTENNA UNIT jack on the power injector.

From

Antenna

2. Connect the short coaxial cable built into the power injector to your TV’s ANTENNA IN jack.

Note: If your TV has screw terminals for the VHF/UHF connection, connect a 75-ohm to a 300-ohm transformer (not supplied) between the power injector and the VHF/UHF terminals.

TV

Power Injector

Coax

 

TV

From

Antenna

Coax

 

 

Splitter

Alternative

Power Injector

 

Component or

 

Display

 

If you want to split the signal coming from the antenna, connect the short coaxial cable built into the power injector to your splitter. DO NOT PUT

THE SIGNAL SPLITTER BETWEEN THE INJECTOR AND THE ANTENNA.

3.Plug the injector’s built-in power supply to the outlet after all connections are complete.

IMPORTANT: This power unit is intended to be oriented in a vertical or floor mount position.



ANT806

 

_IB_01.indd 6

 

 

 

 

 

 

 

 

 

 

 

 

5/2/07 3:29:28 PM

Page 6
Image 6
RCA ANT806 owner manual Connecting the Antenna to Your TV, To connect the antenna to your TV, follow these steps