RCA MAF15BKR installation manual Mounting the wall plate, Hardware Kit, Drywall Installation

Hardware Kit	(F) M8 x 63 Lag Bolt (x3)
(A) M4 x 12 Screw (x4)	(G) Concrete Anchor (10mm, x3)
(B) M4 x 20 Screw (x4)	(H) Washer (9.5mm, x3)
(C) M6 x 12 Screw (x4)	(I) M6 Washer (x4)
(D) M6 x 20 Screw (x4)	(J) 3/16” Drill Bit
(E) 10mm Spacer (x4)

Mounting the wall plate

Drywall Installation

Important! For safety reasons, this mount must be secured to at least two wood studs no less than 16” apart. The studs must be capable of supporting the combined weight of the mount and display.

1.Use a high quality stud fi nder to locate two adjacent studs where you wish to install your mount. Mark both edges of each stud to help identify the exact center.

NOTE: You must use the center of each stud to avoid cracking or splitting the wood during installation.

2.Place the wall plate against the wall and level it using the integrated bubble level.

3.While another person holds the wall plate in position, mark four locations (two per stud) for securing the mount to the wall.

4.Set the wall plate aside and drill a 3/16” pilot hole at each marked location.

5.Place the wall plate back against the wall and attach it using the lag bolts (F) and lag bolt washers

(H) (see Fig. 1). Do not over-tighten these bolts and do not release the wall plate until all bolts are in place. Ensure that the wall plate remains level after all bolts are secured.

Fig.1

Concrete/Brick Installation

IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the combined weight of the mount and the display. The manufacturer takes no responsibility for failure caused by walls of insuffi cient strength.

1.Place the wall plate against the wall in the desired location and level it using the integrated bubble level.

2.While another person holds the wall plate in place, mark six evenly spaced locations on the wall for securing the mount.

3.Set the wall plate aside and drill a 10 mm (3/8”) hole at each marked location. Remove any excess dust from the holes.

4.Insert a Concrete Anchor (G) into each hole so that it is fl ush with the concrete surface. A hammer can be used to lightly tap the anchors into place if necessary.

5.Place the wall plate back against the wall and attach it using the lag bolts (F) and lag bolt washers

(H). Do not over-tighten these bolts and do not release the wall plate until all bolts are in place. Ensure that the wall plate remains level after all bolts are secured.

2