RCA P46921 manual Using Direct Entry, Using the Remote to Control a Component, Modes of Operation

USING THE REMOTE

If the component you want to control does turn off:

1.Press and release REVERSE, then wait 2 seconds. Repeat this step until the component turns back ON.

2.To finish, press and hold STOP until the light on the remote turns off.

Using Direct Entry

1.Turn on the component to be programmed.

2.Look up the brand and code number(s) for the component on the code list on the last page of this section, Using the Remote.

3.Press and hold the button on the remote you want to program.

4.Enter the code from the code list.

5.Release button, and then press ON•OFF to see if the component responds to the remote commands. If it doesn’t, try pressing the component button and then ON•OFF again.

6.If you get no response, repeat these steps using the next code listed for your brand, until the component responds to the remote commands.

USING THE REMOTE TO CONTROL A

COMPONENT

Once the remote has been programmed successfully, you are ready to use it to control your components.

To operate the component:

1.Press the component button (VCR1, VCR2, AUX, or SAT•CABLE) to set the remote to control the component.

2.Press ON•OFF to turn the component ON or OFF.

3.Use the remote buttons that apply to that component.

MODES OF OPERATION

Because this universal remote can control several different components (DVD player, VCR, Cable Box, etc.) it uses operational modes triggered by the component buttons. For example if you want the remote to control the TV, you would press the TV button to put the remote into TV mode before you could control the TV.

25