RCA 40-5019 manual WattPowered Subwoofer with Remote, Tandy Corporation All Rights Reserved

40-5019.fm Page 1 Monday, October 11, 1999 7:32 AM

200-Watt Powered Subwoofer with Remote

Your RCA PRO-SW200P 200-Watt Powered Subwoofer is designed to give you the best possible low-frequency sound for the ultimate home theater experience. You will be astonished by the realism it adds to movie sound effects and the power it lends to all kinds of music.

The subwoofer combines the power of a built-in 200-watt RMS amplifier with a responsive, 12-inch coated paper cone woofer — all housed in a ported bass-reflex enclosure to produce tight, floor-rumbling powerful bass (down to 36 Hz) that you can feel as well as hear!

The infrared remote control lets you regulate the subwoofer’s volume without interrupting your listening.

Your subwoofer has an adjustable high cut filter and high- and low-level inputs so it is easily incorporated into existing systems, or it can be an integral part of a subwoofer/ satellite combination. Its other features include:

Auto On/Off — automatically switches the subwoofer’s amplifier to standby if the subwoofer does not receive a signal for 8–11 minutes.

Power Indicator — the red indicator on the subwoofer’s volume control lights when the amplifier receives an audio signal, and turns off when the amplifier goes into standby mode, so you can see at a glance when the subwoofer is operating.

High-Level Input — lets you connect the subwoofer to an amplifier’s or receiver’s speaker outputs.

Note: You need speaker wire (not supplied) to connect the subwoofer to an amplifier or receiver’s speaker outputs.

Low-Level Input —lets you connect the subwoofer to an amplifier’s or receiver’s subwoofer out or pre out jacks. These inputs automatically sum left and right channel information.

Note: You need phono cables (not supplied) to connect the subwoofer to an amplifier or receiver’s subwoofer out or pre out jacks.

Volume Control — lets you match the subwoofer’s output level to your satellite speakers’ output (if used). Rotate the control clockwise to increase, or counterclockwise to decrease, the subwoofer’s output.

Phase (Polarity) Switch — Inverts the subwoofer’s output polarity so you can set it to match the main speakers.

Frequency Hz Control — lets you set the high frequency cutoff point. Rotated fully clockwise, the subwoofer cuts high frequencies over 200 Hz. Rotated fully counterclockwise, it cuts high frequencies over 50 Hz.

© 1999 Tandy Corporation.

All Rights Reserved.