ATTACHING FEET
Using the supplied screws, secure the four protective feet (packed separately) into the threaded inserts at each corner of the cabinet’s bottom.
CONNECTING TO AN AMPLIFIER
Right Speaker
+–
Amplifier/Receiver | Left | |
Sub Out/Pre Out Terminal Speaker | ||
HIGH LEVEL INPUT | Rec Out |
|
HIGH LEVEL OUTPUT |
|
|
+ R – – L + | L |
|
| R |
|
+ –
| HIGH LEVEL INPUT |
|
|
|
|
| |||
+ | R | - | + | L | - |
|
|
|
|
|
|
|
|
| LOW LEVEL |
| PHASE |
| |
|
|
|
|
| INPUT |
|
| FREQUENCY | |
|
|
|
|
|
| VOLUME |
| ||
POWER |
|
|
|
| L | REV | NORM | HZ | |
|
|
|
|
| CONTROL |
|
| 80 | |
STANDBY |
|
|
|
|
|
|
| 60 | 100 |
RED |
|
|
|
| R |
|
|
| 150 |
+ | R | - | + | L | - |
|
| 50 | 200 |
HIGH LEVEL OUTPUT | MIN MAX |
You can connect your
Notes:
•You can connect your
•See “Connecting to Subwoofer Out or Pre Out Terminals” or “Connecting to Speaker Terminals.”
Caution: To avoid any damage to the subwoofer or amplifier, disconnect power from your components before making any connections.
Connecting to Subwoofer Out or Pre Out Terminals
Use this connection if your amplifier/ receiver has jacks labeled SUBWOOFER OUT or PRE OUT. Do not use the PRE OUT jacks if they are already connected by cables or jumpers to your amplifier.
1.Connect the
4
2.Connect your satellite speakers (if any) to the amplifier’s or receiver’s output terminals as they would normally be connected.
Notes:
•On some receivers/amplifiers, the subwoofer out is a single jack. Use a single phono cable to connect the subwoofer jack to the “L” input on the
•When connecting to a TV, we recommend using variable line output jacks, which will allow the PRO- SW200P’s volume to change with the TV’s volume. Refer to your TV owner’s manual. Also, you can connect to the TV line out and then adjust the TV volume up or down. If the subwoofer volume changes with the TV volume, then the TV line out is variable.
