RCA RCD175 user manual Auxiliary input, Troubleshooting Tips, Additional Information, Volume

Auxiliary input

1.Connect the auxiliary device to the AUX IN jack with an audio cable (not provided).

2.Press SOURCE until the indicator “ ” lights on the display.

3.Start playback from the auxiliary device.

4.Adjust the auxiliary device to mid-range volume

and adjust the master volume by pressing

VOLUME .

•Do not turn the volume of the auxiliary device too high as this may affect the sound quality.

•For other playback operations, control them on your auxiliary device.

Troubleshooting Tips

System doesn’t turn on

•Unplug the unit for a moment, and then plug it back in.

•Check the outlet by plugging in another devices.

No sound

•Adjust volume setting.

•Make sure you’ve selected the correct function.

Poor radio reception

•Rotate the unit for better reception.

•Try turning off electrical appliances near the unit, such as hair dryers, vacuum cleaners or fluorescent lights.

CD doesn’t play

•Make sure you’ve put a CD in the tray.

•Make sure the CD’s label is facing up.

•Try another CD.

•Make sure that Pause mode is not activated.

•Make sure CD function is selected.

CD sound skips

•Clean the CD.

•Check CD for warping, scratches or other damage.

•Check for vibration or shock that may affect the unit; move the set if necessary.

ESD Remark:

In case of misfunction due to electrostatic discharge just reset the product (disconnect and reconnect of the power source may be required) to resume normal operation.

Additional Information

Cleaning the exterior

•Disconnect the system from AC power before clean- ing the exterior of the unit with a soft dust cloth.

•Clean the exterior with a soft clean cloth or slightly moistened chamois leather. DO NOT use solvents as it may cause damage to the unit.

Handling CDs

•Do not touch the signal surfaces. Hold CDs by the edges, or by one edge and the hole.

•Do not affix labels or adhesive tapes to the label surfaces. Do not scratch or damage the label.

•CDs rotate at high speeds inside the player. Do not use damaged (cracked or warped) CDs.

•Make sure CDs are stored in their original case after use. Keep them away from damp, humid or abnormally heated places.

CD Lens Care

•When your CD lens gets dirty it can also cause the system to output poor sound quality. To clean the lens you will need to purchase a CD lens cleaner which can maintain the output sound qual- ity of your system. For instructions on cleaning the CD lens, refer to the ones accompanying the lens cleaner.

Cleaning CDs

•Dirty CDs can cause poor sound quality. Always keep CDs clean by wiping them gently with a soft cloth from the inner edge toward the outer perimeter.

•If a CD becomes dirty, wet a soft cloth in water, wring it out well, wipe the dirt away gently, and then remove any water drops with a dry cloth.

•Do not use record cleaning sprays or antistatic agents on CDs. Also, never clean CDs with ben- zene, thinner, or other volatile solvents which may cause damage to disc surface.

Cassettes

•To protect your recordings from accidental erasure on one or both sides of your cassette, snap out the tab at the top of the cassette. If you decide later to record on the tape, seal the hole with a piece of adhesive tape. (Refer to diagram)

•Quit Slacking - A little bit of slack in your tapes can cause scratches on the tape, or worse yet, the tape could break. If you notice some slack in the tape, use a pencil to tighten it up before you insert it.

EN - 6

811-317591W012 EN & FR & ES IB OK Kelly.indd 6 9/16/2010 4:58:18 PM