RCU404_US_IB_REVB 7/16/03 15:34 Page 6
Program for VCR—
Direct Entry Method
In order for the 4 component universal remote to control your VCR, you must program it with the code that matches your VCR. These instructions explain the preferred method of programming the
CODE INDICATOR
SEARCH LIGHT
VCR (BLINK)
1 2 3
4 5 6
7 8 9
0
(OFF)
ON•OFF
VCR CODE
1.Manually turn on the VCR.
2.Locate the enclosed VCR Code List. Find your brand of VCR.
Note: If your brand isn’t listed, use one of the Code Search methods to program this remote control (See Code Search on page 9).
3.Press and hold the CODE SEARCH key until the indicator light illuminates. Then release the CODE SEARCH key.
4.Press and release the VCR key. The indicator light blinks and then remains lit.
5.Use the number keys on the remote to enter the first code listed for your brand.
After you enter a valid
Note: If you enter an invalid code, the LED will flash rapidly for 2 seconds. Start over at step 3.
6.Aim the remote at the VCR. Press the ON•OFF key. If your VCR turns off, you have found the correct code.
7.Enter the code in the box provided on this page for future reference.
8.If your VCR doesn’t turn off, repeat steps
If none of the codes work or your brand is not listed, use one of the Code Search methods to program this remote (See Code Search on page 9).
For a description of each key on the remote control, refer to the Key Descriptions section on page
6