RCA RP-3761 manual Setting time, Adjusting display brightness, Press and hold

THE DIGITAL CD CLOCK RADIO

Protection against mains power failures:

--Connect a 9-volt battery

(IEC 6LR61 or NEDA 1604A)

--When the battery is used up, the digits flash on and off when the power comes back on

Battery compartment at the backside of the unit

NOTE: Alkaline (IEC 6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be used but memory holding time will be substan- tially reduced. Memory holding time for a fresh alkaline battery is approxi- mately 8 hours (if radio or alarm are not operated) which should take care of short, nuisance-type AC power failures. To preserve battery life, the unit should remain plugged into an AC outlet. As the battery gets older, its voltage drops and memory may be lost. Be sure to replace the battery periodically. Battery should be removed if the unit will be stored for more than one month. Leaky battery can badly damage the clock radio.

Setting time

				TIME SET
		1	Press and hold
		2	Press	or
1. Press and hold		or		to skip fast
		2
2. The AM LED indicator will light to show AM time
Adjusting display brightness
You may slideOFF	DIMMER ON on the left side of the unit to vary the LED
display brightness. When you slide to OFF, the display will be
manintained at the brightness level; slide to ON, the display will vary
automatically according to the environment.
2
RP3761	6			7/20/00, 3:18 PM