CONNECTIONS
| INPUT |
| TAPE/DCC | TAPE 2 |
|
| |
PHONO | CD | VCR/ | REC | PLAY | REC __ PLAY |
| LINE |
L | L | LD |
| L | L |
| |
|
| INPUT | OUTPUT | ||||
|
|
|
|
|
| REC | PLAY |
|
|
|
|
|
| CONTROL |
|
|
|
|
|
|
| L |
|
R | R |
|
| R | R | R |
|
|
| OUT |
| ||||
Receiver/Amplifier | L | R | R | L | L | R | R | L |
LINE OUT
CD•DECK
LSYNCHRO CONTROL
R
IN 
OUT
CD Player
CONNECTING TO YOUR RECEIVER/AMPLIFIER
1.Using one of the supplied audio cables, connect the cassette deck’s L and R LINE OUTPUT jacks to the receiver/amplifier’s left and right tape input jacks.
2.Using the other audio cable, connect the cassette deck’s LINE INPUT jacks to the receiver/amplifier’s tape output jacks.
Note: If you are not sure which receiver/amplifier jacks to use, refer to your receiver/amplifier’s owner’s manual.
CONNECTING THE REMOTE CONTROL CABLE
If you have an RCA receiver/amplifier that has a remote control jack (labeled CONTROL IN/OUT), you can use the receiver/amplifier’s remote control to operate the cassette deck.
Connect the receiver/amplifier’s CONTROL OUT jack to the cassette deck’s CONTROL IN jack using the supplied remote control cable.
If you have another RCA audio component that has a remote control jack, connect the cassette deck’s CONTROL OUT jack to the component’s CONTROL IN jack. This relays the remote control signal from the receiver/amplifier to the other component.
CONTROL
CD¥DECK IN OUT
SYNCHRO
CONNECTING THE CD-DECK SYNCHRO CONTROL CABLE
If you have a CD player that has a
CONNECTING POWER
Carefully check all connections. Then plug the AC power cord into a standard AC outlet. The power cord’s plug is polarized and fits only one way. The cassette deck automatically turns on.
Warning: To prevent electric shock, do not plug the power cord into an extension cord or other receptacle unless you can fully and easily insert the plug’s blades.
5
