WHR100 Manual(1J1369) 6/10/99 1:43 PM Page 6
OPERATION OF TRANSMITTER
The Green Auto ON/OFF indicator will be onwhen you plug the adapter in the AC source and connect the audio plug to the audio source. If the Auto On indicator is not lit (but the audio source is ON) adjust the audio source output level which is greater than the auto on indicator light in input level.
For protection of the transmitter and to save power, the transmitter will be cut off automatically in the about one minute when the input signal from audio source is too weak for operation.
Auto ON Indicator 
CAUTION: Under normal working condition, the surface of the transmitter will be slightly hot.
NOTE: | High levels from source may overload the |
| transmitter. |
BATTERY INSTALLATION
1)Remove battery door by pushing in on the arrow at the bottom of cover.
2)Insert one AAABattery for each headphone earcup.
3)Replace the battery door cover by sliding in the opposite direction of the arrow until it “snaps”.
When using the
OPERATION OF HEADPHONE RECEIVERS
1)Set the Headphone Receiver’s VOL control to the minimum position.
2)Turn the Receiver’s ON/OFF switch to ON.
3)Increase the Receiver’s VOL control setting slowly until you hear the sound source which is connected to the transmitter. Then, adjust the Receiver’s VOLcontrol for the desired lis- tening level.
4)Adjust the size of the headphone by pulling down each end (or pushing up to shorten).
