Philips SRU 1020 manual Contents, Introduction, Installing the remote control

4ENGLISH

	Contents
1.	Introduction	4
2.	Installing the remote control	4-6
	Inserting the batteries	4
	Testing the remote control	4
	Setting the remote control	5-6
3.	Keys and functions	6-7
4.	Extra possibilities	7-9
	Adjusting device selection (Mode keys)	7
	Activating/deactivating child lock function	7-8
	Storing favorite TV channels/Learning keys	8-9
	Restoring the original functions of your remote control	9
5.	Troubleshooting	9
	Code list of all brands/equipment	94-101
	Information to the Consumer	103

1. Introduction

Congratulations on your purchase of the Philips SRU 1020 universal remote control. After installing the remote control you can operate a maximum of 2 different devices with it:TV and DVD players/recorders. You can find information about how to prepare this remote control for use in the chapter ‘Installing the remote control’.

2. Installing the remote control

Inserting the batteries

1Press the cover inwards and lift it up.

2Place two R03, UM4 or AAA type batteries into the battery compartment, as shown.

3Replace the cover and click it firmly into place.

Testing the remote control

Because the SRU 1020 may use different signals for each brand and even for different models of the same brand, it is advisable to test whether your device responds to the SRU 1020.The example below (TV) instructs you how to do this.You can repeat the same steps for your DVD player/ recorder.

1Turn your TV on manually or use the original remote control.Tune to channel 1.

2Check whether all the keys are working. For an overview of the keys and their functions see ‘3. Keys and functions’.

–If the TV responds as it should to all of the key commands the SRU 1020 is ready for use.

•If the device does not respond at all or not to all of the key commands, follow the instructions under ‘Setting the remote control’ or for online setup got to: www.philips.com/urc.