MOUNTING ENGINE
1.Loosen the bolts temporarily attached to
the clutch housing.
2.Push the driveshaft toward the gearcase
and rotate it by hand to check that the
driveshaft is engaged with the gears.
3.Insert the shaft tube into the clutch
housing until it bottoms. When difficult to
engage, twist the engine slightly.
4.Align the positioning holes on the clutch
housing and the shaft tube and fit the boss
on the clamp into the holes. And fasten
the bracket with 2 bolts securely.
INSTALLING HANDLE
•Mount the handle to the shaft tube and
clamp it at your best operating position.
INSTALLING DEBRIS GUARD
•Put the debris guard on the shaft tube near
the gear box, attach it with the 2 screws
and hardware provided.
CONNECTING THROTTLE WIRE
1.Remove the air cleaner cover.
2.Connect the end of the throttle wire to the
joint on the top of the carburetor.
CONNECTING SWITCH WIRES
•Connect the switch wires between the
engine and the main unit. Pair the wires of
the same color.
INSTALLING CUTTING HEAD
1.While locking the gear shaft by inserting
the attached bar into the upper holder and
the gear box, loosen and remove the
hexagon bolt(left-handed)
2.Fit the spacer attached to the head
assembly between the upper and lower
holders. Then screw in the cutting head to
the gear shaft over the holders. Hand-
tighten it securely.
Set up
9