8. Maintenance
WARNING
Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down and squeeze spray pistol (aim away from you).
Pressure will escape; when hissing stops, all pressure has been released. Remove pump assembly by turning
1.Remove cap and pour out remaining solution, then rinse all parts thoroughly with clean water.
2.Add 1/2 gallon of fresh water in tank. Pressurize, and flush pumping system by depressing trigger for at least two minutes; then drain all remaining water.
•Periodically
•To ensure good performance, keep lid vent free of obstruction. Before and after each use, make sure all connections are well tightened. Service and replace worn parts as required.
NOTE
Failure to follow manufacturer's recommendation of use and care of unit will void any expressed or implied warranty. Do not use chlorine or clorox. It will permanently damage pump system.
NOTE
In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest RedMax authorized servicing dealer for assistance.
■SPRYAER MAINTENANCE TABLE
|
| Dayly |
|
System/Compornent | Procedure | or |
|
|
| Before Use | After Use |
|
|
|
|
Lid Gasket | Grease | ✓ |
|
|
|
|
|
Lid Vent | Inspect/Clean | ✓ |
|
|
|
|
|
Pump | Grease | ✓ |
|
|
|
|
|
Connection | Inspect/Tight | ✓ |
|
|
|
|
|
Whole unit | Wash/inspect |
| ✓ |
|
|
|
|
9. Storage
WARNING
Never store chemicals in your sprayer for any length of time
1.Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down and squeeze spray pistol (aim away from you). Pressure will escape; when hissing stops, all pressure has been released. Remove pump assembly by turning counter- clockwise. The pump handle has two locking positions, one turning clockwise and one
2.Remove cap and pour out remaining solution, then rinse all parts thoroughly with clean water.
3.Add 1/2 gallon of fresh water in tank. Pressurize, and flush pumping system by depressing trigger for at least two minutes; then drain all remaining water.
4.Always store tank clean and empty in a dry, shaded location.
10. Disposal
When disposing your machine, or chemical, be sure to allow your local regulations.
7
