![](/images/new-backgrounds/1114601/11460121x1.webp)
EBZ3050RH
8. Operation
■ STARTING ENGINE
|
|
| IMPORTANT |
|
|
|
|
|
|
| • | Avoid operating the blower with the | ||
|
|
| flexible tube and swivel joint | |
|
|
| disconnected. That will reduce the | |
|
|
| cooling air and the engine could be | |
|
|
| damaged by overheating. | |
|
|
| ||
F6 | 1. | Push the primer bulb until fuel flows out | ||
|
|
| in the clear tube. (F6) | |
| (1) Primer Bulb | |||
|
|
|
|
|
F7 | 2. When the engine is cool, close the | ||
choke. (F7) | |||
| |||
| (1) | Choke Lever | |
| (2) | CLOSE | |
| (3) | OPEN | |
|
|
|
F10
F11
engine cover reach high temperatures during operation and doing so could result in serious burns.
U
6. Once the engine is running, gradually
S
open the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up.
NOTE
When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope.
■ADJUSTING IDLE SPEED (F10)
•The idling speed is set for 3000 rpm at the factory. If it is necessary to adjust
(1)the idle speed, use the adjustment screw on the top side of carburetor.
(1) Idling Adjustment Screw
■STOPPING ENGINE
F8
(3)
(1)
(2)
F9
3.Set the ignition switch to the start position. (F8)
4.Set the throttle lever in idling position. (F8)
(1)Full Throttle
(2)Idling
(3)Ignition Switch
5.To start, hold the top of the blower firmly and hold the flame by your foot. Pull the starter knob slowly until you feel it engage and then give it a vigorous strong pull. (F9)
IMPORTANT
•Avoid pulling the starter rope out to its full extent and allowing the starter rope to snap back. This will prevent premature damage to the starter.
•Do not let a person stand near the blower or the exhaust port.
•Never to touch the muffler, spark plug, other metallic parts of the engine or engine cover while the engine is in operation or immediately after shutting down the engine. These metallic parts and
F12
•Move the throttle lever to the idling position and set the ignition switch to the stop position. (F11)
(1)
(1) Ignition Switch
NOTE
If the engine won’t stop when setting the ignition switch to the stop position, close the choke lever and stop the engine.
In this case, please repair the machine at your nealest servicing dealer. (F12)
(1)Choke Lever
(2)CLOSE
(3)OPEN