EBZ5150/RH
9. Maintenance
Maintenance, replacement, or repair of the emission control device and systems may be performed by any
|
| Daily | Every | Every | Every |
System/Compornent | Procedure | or | 25 hours | 50 hours | 100 hours |
|
| Before use | after | after | after |
Air Filter | Inspect/Clean |
| ✔ |
|
|
Fuel Leaks | Inspect/Replace | ✔ |
|
|
|
Fuel Filter | Inspect/Replace | ✔ | ✔ |
|
|
Fuel Line | Inspect/Clean | ✔ |
|
|
|
Spark Plug | Inspect/Clean |
| ✔ |
|
|
Muffler | Inspect/Clean | ✔ |
|
|
|
Muffler Spark Arrester | Inspect/Clean |
|
| ✔ |
|
Cooling System | Inspect/Clean | ✔ |
|
|
|
Screws/Nuts/Bolts | Tighten | ✔ |
|
|
|
Cylinder Exhaust Port | Inspect/Clean |
|
|
| ✔ |
U S
WARNING
Make sure that the engine has stopped and is cool before performing any service to the blower. Contact with rotating blower fan or hot muffler may result in a personal injury.
•Do not use mixture gasoline. This type of gasoline does not contain much of oil so that the element becomes dry after a few hours.
(1) 2 Cycle Motor Oil
NOTE
■AIR CLEANER
• | Never operate the blower without an air |
| filter or with a deformed or broken filter |
| element because unfiltered dusty air |
| will quickly ruin the engine. |
• | Check the air cleaner every 25 hours |
Soak the filter element into a 2cycle motor oil. Squeeze the element to remove excess oil so that it weighs 2 to 3 times heavier than that of the dry element.
F18 |
of use or more frequently if used |
under dusty conditions. A clogged |
air filter may increase fuel |
consumption while cutting down the |
engine power. Never operate the |
blower without the air filter or with a |
deformed filter element because |
unfiltered dusty air may quickly ruin |
the engine. |
F20 |
| (3) |
|
| |
(1) | (4) | (2) |
| ||
|
| |
|
| (5) |
3.Place the filter element into the packing. Set the packing into the air cleaner body. Set the cover with 2 fixing screws.
(1)Cover Cleaner
(2)Screen
(3)Cleaner Body
(4)Element
(5)Packing
F19 |
CLEANING AIR FILTER:
1.Remove the air cleaner cover by pulling the tab on bottom and take out the filter element.
2.Use neutral detergent and warm water to clean the filter element. After cleaning, air dry the element completely and moisten with a small amount of 2 cycle motor oil.
NOTE
•Do not apply 4cycle motor oils as they may damage element.
NOTE
•Assure that the screen is securely fitted to the packing. Fit securely if it is loose.
•Insufficient fixing of screws may cause fall off of the cover and insufficient sealing.
IMPORTANT
Place the filter element into the packing. Set the packing into the air cleaner body. Set the cover with 2 fixing screws.
