RedMax HE2601 manual 10 , Operation, Stopping Engine, Adjusting Idling Speed

Operation

5.While pulling the throttle trigger with the little finger of your left hand, pull the starter rope.

NOTE

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

6.When the engine has started, move the choke lever gradually downward to open the choke.

7.Allow the engine to warm up for a half minute before starting operation.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

■STOPPING ENGINE

1.Release the throttle trigger and run the engine for a half minute.

2.Shift the ignition switch to the STOP position.

NOTE

•Except for an emergency, avoid stopping the engine with the trigger pulled on.

■ADJUSTING IDLING SPEED

1.When the engine tends to stop frequently at idling mode, turn the adjusting screw clock-wise.

2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw counter-clockwise.

NOTE

1.After setting up the unit, check play of the throttle cable. The normal play is between

.04" and .08" (1mm and 2mm).

2.Warm up the engine before adjusting the idling speed.

10 