RedMax CHTZ2500 manual Operation,  16 , OP22, Starting Engine, throttle lever

7. Operation

OP1

(1)

OP2(2)

(4) (3)

OP3 (5)

(6)

OP4

[HTZ2500]

[CHTZ2500]

■STARTING ENGINE

WARNING

The cutting head will start rotating upon the engine starts.

1.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine.

2.Push the primer pump several times until overflown fuel flows out in the clear tube. (OP1)

3.Move the choke lever to the closed position. (OP2)

4.Set the ignition switch to the “START” position. (OP3)

(1)primer pump

(2)choke lever

(3)close

(4)open

(5)ignition switch

(6)throttle lever

5.Holding the hedge-trimmer down, pull the starting rope slowly until you meet resistance (OP4). Then operatel hard several times, and when the engine starts, wait for about 10 seconds and then pull the throttle lever (OP3(6)), the choke lever (OP2(2)) will return automatically to the original “OPEN” position.

WARNING

Use the semi-acceleration device only in the phase of starting the engine.

IMPORTANT

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

16 