8. Operation
OP5
.04 in
(1~2mm) (1)
OP6
(1)
■STOPPING ENGINE (OP3)
1.Release the throttle lever and run the engine for a half minute.
2.Shift the ignition switch to the STOP position.
IMPORTANT
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
■ADJUSTING THROTTLE CABLE
•The normal play is 1 or 2mm when measured at the carburetor side end. Readjust with the cable adjuster as required. (OP5)
(1) cable adjuster
■ADJUSTING IDLING SPEED (OP6)
1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw
(1) idle adjusting screw
NOTE
•Warm up the engine before adjusting the idling speed.
WARNING
This product is equipped with extremely sharp blades, and when used improperly these blades can be extremely dangerous, and improper handling can cause accidents which may in turn lead to serious injury or death. For this reason, you should always be careful to follow the following instructions when using your trimmer.
•Never hold the trimmer in a way in which the blades are pointed towards someone else.
•Never allow the blades to come into proximity with your body while the engine of the trimmer
