8. Operation
OP7
is in operation.
•Always be sure to turn off the engine before changing the angle of the blades, removing branches which have become stuck in the blades, or at any other time when coming into close proximity with the blades.
•Always wear work gloves made of leather or some other sturdy material when using the trimmer.
•Always place the blade cover provided with the trimmer over the blades when not in use.
•Falling branches may fall onto the face or into the eyes, resulting in injuries, scratches, and cuts, and for this reason you should always be sure to wear a helmet and face protector when using your trimmer.
IMPORTANT
The thickness of branches which may be cut using this trimmer is limited to up to approximately 3/16" (5mm). Never try to cut branches thicker than this, as doing so may result in damage to the trimmer.
■ADJUSTING THE ANGLE OF THE CUTTING BLADES (OP7)
1.Stop the engine.
2.Turn the bolt located on the top of the trimming mechanism
3.Adjust the angle of the blades to the desired angle, and then fix the bolt firmly back into place.
(1)Clamp lever
(2)Trimming mechanism
