5. Set up
SE1
SE2
SE3
■MOUNTING ENGINE (SE1)
1.Install the engine to the driveshaft so that the cylinder head and the stop switch may come on the same side.
2.Using attached four bolts, secure the connection firmly with equal force (Torque:
(1)Bolt
(2)Stop switch
WARNING
Never use any screws other than those specified by the manufacturer, or the engine can get loose, resulting in a hazardous event.
IMPORTANT
Tighten the screws gradually by turns.
■CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)
■CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.
■INSTALLING HANDLE
•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)
