7. Operation
RECOMMENDED APPLICATIONS:
Parking area
Among trees
Near fences
Road side
Road edge
Water side
Aroud stones
18
machine control.
3.Since the blade does not cause cut grass to wrap around the neck, you need not to stop operation to remove such wrappers.
What's more, since the whole circle of the blade is available for cutting, you can move the cutting head in all directions and cut grass growing on such place
You can even trim the waterside without splashing water.
■CUTTING WORK
WARNING
1.Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
2.Keep the debris guard attached in place at alltimes when the unit is operated.
•Adjust the front handle to the most comfortable position.
•Start the engine and pull the throttle lever gradually. The blades will start moving as the engine speed goes up.
•To stop the blade motion, simply release the throttle lever. The clutch will disengage and the blades stop moving while the engine keeps idling.
•Move the cutting head as sliding its bottom on the ground. This will help you do the job with less effort.
NOTE
•Avoid running the engine at full throttle with no load. Continuous no load full throttle operation can cause damage to the engine and driveshaft.
•Operation at too slow engine speed can cause abnormal vibration of the machine, resulting in short life of driveshaft and clutch parts. If you felt such vibration, use a higher speed range.
•Though the blades are made of harder steel compared to conventional metal blades, continuous cutting in soil will accelerate wear.
