Diagram 4 The spray head rotates through approximately 140o
IN ORDER TO MAINTAIN THE
PERFORMANCE OF YOUR
SHOWER YOU MUST CLEAN
THE SHOWERHEAD.
NOTE: After use it is normal for some water to drip from the shower head for a few moments.
HOW TO MAINTAIN YOUR 'REDRING' POWER SHOWER
All water contains particles of lime which build up in the showerhead and unit reducing the performance. It is therefore important to clean the showerhead by dipping it in a suitable descaling solution. The frequency of this will vary depending on site water conditions.
Cleaning
WARNING: Switch off the electricity at the isolating switch to avoid the shower accidentally switching on during cleaning.
It is recommended that the shower unit and accessories are cleaned using a soft cloth.
DO NOT use powerful abrasive or solvent cleaning fluids.
WHAT TO DO IF THINGS GO WRONG
Self Help
If the performance of the shower does deteriorate in service make the following checks before calling out the contractor. Any one of these simple adjustments could restore the performance.
a)System will Check that the mains
not operate electrical supply is switched on.
b) Pump | Check that water is available |
operates but | to both ports, and that all |
no water is | isolating valves are open. |
delivered | Check for an airlock in the |
| pump chamber. Repeat |
| commissioning procedure on |
| page 9. |
|
|
c)Water too Turn Temperature Control Knob
cold | (B) |
| number on the temperature |
| scale (see diagram 1). |
| Check that hot water is |
| available in the hot water |
| cylinder. The ideal thermostat |
| setting for the hot water |
| storage cylinder is 60oC |
| (140oF). |
| Check that the HOT water |
| isolating valve is open. |
| If possible, reposition |
| temperature limiting device so |
| that more movement of Knob |
| 'B' is allowed. |
|
|
d)Water too Turn Temperature Control
hot | Knob (B) clockwise to a lower |
| number on the temperature |
| scale. Check that the COLD |
| water isolating valve is open. |
|
|
e)Poor spray Clean showerhead (see
pattern opposite).
Professional Service
If the above checks fail to restore the performance, you should seek professional help.
The person who installed the shower is probably the best one to repair it and is certainly the person to contact if you have a problem in the guarantee period.
The following additional checklist is provided for the benefit of the qualified serviceman.
WARNING: SWITCH OFF THE ELECTRICITY AT THE ISOLATING SWITCH BEFORE REMOVING THE COVER TO MAKE CHECKS.
|
|
|
a) Pump | Check that the inlet connections | |
operates but | to the mixing chamber are piped | |
no water is | correctly. | |
delivered | Check that the shower and all | |
| pipework are sited below the level | |
| of the cold water tank and that it | |
| is fully primed and is therefore not | |
| airlocked. See commissioning | |
| procedure (page 9). | |
|
|
|
4
