PROBLEM: The walking belt is |
|
|
|
|
SOLUTION: a. If the walking belt is |
|
|
|
|
UNPLUG THE POWER CORD. If the walking belt |
| a |
| |
has shifted to the left, use the hex key to turn the |
|
|
|
|
|
|
|
| |
left idler roller bolt clockwise 1/2 of a turn; if the |
|
|
|
|
walking belt has shifted to the right, turn the left |
|
|
|
|
idler roller bolt counterclockwise 1/2 of a turn. Be |
|
|
|
|
careful not to overtighten the walking belt. Plug in the |
|
|
|
|
power cord, insert the key, and run the treadmill for a |
|
|
|
|
few minutes. Repeat until the walking belt is cen- |
|
|
|
|
|
|
|
| |
tered. |
|
|
|
|
b. If the walking belt slips when walked on, first remove |
|
|
|
|
the key and UNPLUG THE POWER CORD. Using |
| b |
| |
the hex key, turn both idler roller bolts clockwise, 1/4 |
|
|
|
|
of a turn. When the walking belt is correctly tight- |
|
|
|
|
ened, you should be able to lift each edge of the |
|
|
|
|
walking belt 3 to 4 in. (8 to 10 cm) off the walking |
|
|
|
|
platform. Be careful to keep the walking belt cen- |
|
|
|
|
tered. Then, plug in the power cord, insert the key, |
|
|
|
|
and carefully walk on the treadmill for a few minutes. |
|
|
|
|
|
|
|
| |
Repeat until the walking belt is properly tightened. |
|
|
|
|
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. Hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Press the Stop button and then press the Incline increase or decrease button. The treadmill will automatically rise to the maxi- mum incline level and then return to the minimum level. This will recalibrate the incline system. If the incline system does not calibrate, press the Stop button again, and then press the Incline in- crease or decrease button again. When the incline system is calibrated, remove the key from the console.
PROBLEM: The console display has lines running through it
SOLUTION: a. If lines appear in the console display, see THE INFORMATION MODE on page 18 and adjust the contrast level of the display.
23
