MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries should be replaced. See assembly step 6 on page 7 for replacement instructions. If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 12.
HOW TO LEVEL THE EXERCISE CYCLE
HOW TO ADJUST THE REED SWITCH
If the console does |
| |
not display correct |
| |
feedback, the reed |
| |
switch should be | 8 | |
adjusted. First, use a | ||
| ||
small flat screwdriver |
| |
to carefully pry off the | 14 | |
left Side Shield | ||
Cover (14). Then, |
| |
rotate the left Pedal |
|
Guard (8) and move it away from the left side shield.
Next, locate |
| |
the Reed |
| |
Switch (69). |
| |
Turn the Left | 15 | |
Crank Arm (15) | ||
| ||
until the |
|
If the exercise cycle does not sit flat on your floor, turn one or both of the level- ing feet until the exercise cycle is level.
Leveling Feet 
Magnet (23) is |
|
|
aligned with | 69 |
|
the Reed | 23 | |
Switch. |
| |
66 |
| |
Loosen, but do |
| |
not remove, |
|
|
the indicated |
|
|
M4 x 16mm |
|
|
Screw (66). |
|
|
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the belt may need to be adjusted. To adjust the belt, first remove all the screws from the left and right side shields. Then, carefully remove the right side shield.
Slide the Reed Switch slightly closer to or away from the Magnet. Then, retighten the Screw. Turn the Crank Arm for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the Pedal Guard (8) and the left Side Shield Cover (14).
Next, turn the indicated M8 x 40mm Screw
(58)until the
Belt (28) is properly tight- ened. Then, reattach the right side shield.
58 |
28 |
16
