Reebok Fitness RBTL09906.1 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own Phillips screwdriver .

For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 30. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. To avoid damaging plastic parts, do not use power tools for assembly.

Extension Leg Nut (67)–4	Star Washer (8)–4	1” Tek Screw (83)–4	Screw (3)–2
Console Bolt (64)–4		Extension Leg Bolt (65)–4

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip		84
the treadmill onto its left side as shown. Partially
fold the Frame (58) so the treadmill is more sta-
ble; do not fully fold the Frame until the tread-	65	82
mill is completely assembled.
	82
Attach two Base Pads (82) to the base of the
Uprights (84) with two 1” Tek Screws (83) as		83
shown.
Insert an Extension Leg (89) into the base of the		67
Uprights (84) as shown. Hold two Extension Leg
	89
Nuts (67) in the bottom of the Extension Leg.
Next, insert two Extension Leg Bolts (65) into the	58
top of the Extension Leg, and firmly tighten the
Extension Leg Bolts into the Extension Leg Nuts.
	6