3.With the help of a second person, raise the treadmill Frame (55). Hold the Latch Housing (68) and the Latch Housing Cover (5) against the sides of the Frame as shown. Loosely thread the two
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. The collar should be on the side of the spring shown. Insert the pin into the Latch Housing (68), and tighten the knob back onto it.
Align the pin with the hole in the Left Handgrip (87) by slid- ing the Latch Housing (68) up or down. Make sure that the pin can be inserted fully into the hole. Hold the Latch Housing in place as you tighten two 1/2” Tek Screws (49) into the Latch Housing and the Frame (55). Then, tighten the 1/2” Screws (132). Note: It may be necessary to pull on the knob to access and tighten the Screws.
4.Remove the backing from the indicated tape on the con- sole assembly. Press the Book Holder (50) firmly onto the tape. Note: The Book Holder may be preassembled.
3 |
| |
Hole | Knob | |
87 | 132 | |
5 | ||
68 | ||
| ||
49 | Small | |
Collar | Holes | |
| ||
| 55 | |
Spring |
| |
Pin |
| |
132 | 49 | |
4 |
| |
50 |
| |
Console |
| |
Assembly |
| |
Tape |
|
5.Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor or carpet. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see pages 26 and 27).
7
