HOW TO TURN ON THE POWER
Note: To prevent damage to the walking platform, always wear clean shoes when using the treadmill.
Plug in the power cord (see |
|
|
|
|
|
|
|
|
|
|
|
| |
page 9). Next, locate the |
|
|
|
|
|
|
|
|
|
|
|
| |
reset/off circuit breaker on |
|
|
|
|
|
|
| Reset | |||||
|
|
|
|
| ||
the treadmill frame near the |
| Position |
|
|
|
|
power cord. Make sure that |
|
|
|
|
|
|
|
|
|
|
|
| |
the circuit breaker is in the |
|
|
|
|
|
|
reset position. |
|
|
|
|
|
|
Stand on the foot rails of the treadmill. Find the clip at- tached to the key (see the drawing on page 10) and slide the clip onto the waistband of your clothes. Next, route the cord attached to the clip under the handgrip pulse sensor, and insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.
HOW TO USE THE MANUAL MODE
1 Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2 Select the manual mode.
When the key is in- serted, the manual mode will be selected and the indicator on the Manual Control button will light. If you have se-
lected a program, reselect the manual mode by pressing the Manual Control button.
3 Start the walking belt.
To start the walking belt, press the Start button, the Speed increase button, or one of the twelve Quick Start buttons.
If the Start button or the
Speed increase button is pressed, the walking belt will begin to move at 1
mph. As you exercise, change the speed of the
walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph.
If one of the Quick Start buttons is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting. Note: The console can display speed and distance in ei- ther miles or kilometres. For simplicity, all in- structions in this section refer to miles.
To stop the walking belt, press the Stop button. The time will begin to flash in the Pace/Time dis- play. To restart the walking belt, press the Start button, the Speed increase button, or one of the twelve Quick Start buttons.
Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 27).
4 Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the Incline increase and de- crease buttons. Each time a button is pressed, the incline will change by 0.5%.
Follow your progress with the matrix and the
5 displays.
The matrix—When the
manual mode or the iFIT.com mode is se- lected, the matrix will display a
dicators around the track
will light in succession until the entire track is lit. The track will then darken and the indicators will again begin to light in succession.
11
