Reebok Fitness RBTL13830 manual Key and Unplug the Power CORD. Using, Top, View

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the allen wrench to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b. If the walking belt slips when walked on, first remove	b
the key and UNPLUG THE POWER CORD. Using
the allen wrench, turn both rear roller bolts clockwise,
1/4 of a turn. When the walking belt is correctly tight-
ened, you should be able to lift each side of the walk-
ing belt 3 to 4 inches off the walking platform. Be
careful to keep the walking belt centered. Plug in the
power cord, insert the key, and carefully walk on the
treadmill for a few minutes. Repeat until the walking
belt is properly tightened.
PROBLEM: The SPEED/PACE display on the console does not function properly
SOLUTION: a. Remove the key from the console and unplug the	a
power cord. Remove the screws from the hood and
carefully remove the hood. Locate the Reed Switch	1/8”
(17) and the Magnet (12) on the left side of the Pulley
	66	11
(11). Turn the Pulley until the Magnet is aligned with
		12
the Reed Switch. Make sure that the gap between	17
the Magnet and the Reed Switch is about 1/8”. If
necessary, loosen the Screw (66) and move the Reed	Top
Switch slightly. Retighten the Screw. Reattach the
	View
hood and run the treadmill for a few minutes to check
for a correct speed reading.
PROBLEM: The heart rate monitor does not function properly
SOLUTION: a. If the heart rate monitor does not function properly, see HEART		b
RATE MONITOR TROUBLESHOOTING on page 7.
b. If the heart rate monitor still does not function properly, the battery
should be changed. To replace the battery, locate the battery cover
on the back of the sensor unit. Insert a coin into the slot in the cover
and turn the cover counterclockwise to the “open” position. Remove
the cover.
Next, remove the old battery from the sensor unit. Insert a new CR		CR2032
2032 battery, making sure that the writing is on top. In addition,
make sure that the rubber gasket is in place in the sensor unit.		Battery
Replace the battery cover and turn it to the closed position.		Rubber
		Gasket

28