Reebok Fitness RBTL16921 manual Uprights 65 as shown, with the Bumpers 98 under

3. (Note: The parts shown in this step may be preassembled	3
but may need to be adjusted.) With the help of a second
person, raise the Frame (55) and hold it. Insert the Left
Frame Guide (68) into the left side of the Frame. Remove
the Latch Knob (67) from the Latch Pin (72). Make sure		Hole	55		10
that the Latch Pin Collar (70) and the Spring (69) are on
				5
the Latch Pin. Insert the Latch Pin into the Frame and the			70
Left Frame Guide. Press the Latch Insert (5) onto the			72
Frame, with the Latch Pin in the center hole. Tighten the
Latch Knob onto the Latch Pin.	68		69		67
		62
Align the Latch Pin (72) with the hole in the Left Foam
Grip (62) by sliding the Left Frame Guide (68) up or down.
Make sure that the Latch Pin can be inserted fully into the
hole. Hold the Left Frame Guide in place and tighten two
1/2” Screws (10) into the Latch Insert and the Left Frame
Guide. Note: It may be necessary to pull the Latch Knob
(67) to access and tighten the Screws.
4. Raise the treadmill to the storage position (see HOW TO	4
FOLD THE TREADMILL FOR STORAGE on page 24).
Have a second person hold the treadmill in the upright posi-			13
	26
tion. Position the U-base (20) against the base of the
Uprights (65) as shown, with the Bumpers (98) under the
U-base.Finger tighten two 2” Bolts (26) with Base
Washers (129) into the base of the Uprights and the U-			129
base. Then, attach the U-base with two 3” Bolts (23), two		23			13
Base Washers (129), and two Nuts (13). Tip the treadmill			26
forward if necessary. Tighten the two 2” Bolts.			65
5. Make sure that all parts are properly tightened before			129
	98
you use the treadmill. Place a mat beneath the tread-		20
mill to protect the floor. For your benefit, familiarize your-			98
self with the information on pages 25 and 26.
			23

PART IDENTIFICATION CHART

Use the chart below to identify small parts needed for assembly.

Screw (40)–8	3/4” Screw (101)–4
2” Bolt (26)–2
3” Bolt (23)–2
	Nut (13)–2

Base Washer (129)–4

Plastic Fastener

(75)–4

7