Reebok Fitness RBTL22920 manual Uprights 65 as shown, with the Bumpers 98 under

3. (Note: The parts shown in this step may be preassembled	3
but may need to be adjusted.) With the help of a second
person, raise the Frame (55) and hold it. Insert the Left
Frame Guide (68) into the left side of the Frame. Remove
the Lock Knob (67) from the Lock Pin (72). Make sure that		Hole	55		10
the Lock Pin Collar (70) and the Spring (69) are on the
				5
Lock Pin. Insert the Lock Pin into the Frame and the Left			70
Frame Guide. Press the Latch Insert (5) onto the Frame,			72
with the Lock Pin in the center hole. Tighten the Lock
Knob onto the Lock Pin.	68			69	67
		62
Align the Lock Pin (72) with the hole in the Left Foam Grip
(62) by sliding the Left Frame Guide (68) up or down.
Make sure that the Lock Pin can be inserted fully into the
hole. Hold the Left Frame Guide in place and tighten two
1/2” Screws (10) into the Latch Insert and the Left Frame
Guide. Note: It may be necessary to pull the Lock Knob
(67) to access and tighten the Screws.
4. Raise the treadmill to the storage position (see HOW TO	4
FOLD THE TREADMILL FOR STORAGE on page 24).
	26
			51
	129
Have a second person hold the treadmill in the upright posi-
tion. Position the U-base (20) against the base of the
Uprights (65) as shown, with the Bumpers (98) under the
U-base.Finger tighten two 2” Bolts (26) with Base
Washers (129) into the base of the Uprights and the U-
base. Then, attach the U-base with two 3” Bolts (23), two		23	26		51
Base Washers (129), and two U-base Nuts (51). Tip the
treadmill forward if necessary. Tighten the two 2” Bolts.			65
5. Make sure that all parts are properly tightened before			129
	98
you use the treadmill. Place a mat beneath the tread-		20
mill to protect the floor. For your benefit, familiarize your-			98	23
self with the information on pages 25 and 26.
PART IDENTIFICATION CHART

Extension Screw (50)–8 3/4” Screw (101)–4

2” Bolt (26)–2

3” Bolt (23)–2

Base Washer (129)–4

	Plastic Fastener
U-base Nut (51)–2	(75)–4

7