09
SPR Ay
• Withwaterinthetank,youmayspraywateroverthegarmentbypressing
the button Fig 1 (3).
FILLING WITH WATER
If the water is running out, after approximately 30 seconds the waterfilling icon
will blink to indicate the water tank must be refilled Fig 2 (d). If the tank is not
filled, the pump will stop automatically within one minute to prevent damage to it.
Unplug the iron and fill the tank with the water jug that is supplied Fig 1 (8),
in the vertical position as shown in figure Fig 3.
When the tank is full, the icon does not disappear from the display until you press
the steam On/Off switch and start ironing again.
If the iron were to run out of water completely, you will hear a strange noise from
the micro-pump. In this case, press the steam switch Fig 2 (g) off, then press the
powerbuttonoffFig2(h),unplugtheapplianceandllthetankwithwater.Plug
in the iron, when you press the temperature (On/Off) switch again, this noise will
disappear and you can begin to iron again.
ANTI-SCALE SySTEM
The Digital Velocity V100 is fitted with a replaceable anti-scale system consist-
ing of a resin filter, which retains the mineral substances in the water, preventing
these from reaching the steam chamber in the soleplate and thereby extending
the life of your iron. If you so wish, on this model you may replace the filter so that
the iron is kept in optimum condition. If you want to replace the filter we recom-
mend you to do it every six to twelve months (depending on the type of water you
are using). Changing the filter does not mean that you may overlook the advice
aboutwaterhardnessgiveninthesection“BeforeStartingToIron.”
In the event of not changing the filter of this iron, it will be subject to the effects
of scale just like other irons. For replacement and before removing it, make sure
there is no water in the tank.
Turn the part, situated in the rear of the iron, in an anticlockwise direction as far
as it will go, and the arrow lines up with the open padlock (approx. 180°) and
pull it back.
To replace it, line up the arrow with the open padlock and turn it in a clockwise
direction, following the directions in the drawing, pressing the part inwards at the
same time, until reaching the padlock closed position Fig 9.
Whenthelterisinplace,makesurethatitDOESNOTSTANDOUToftheback
of the iron, otherwise you will not have fitted it properly and water will leak from
the tank.