Disposal
Shaving Tips:
■Ensure your skin is dry and free of oils.
■Always hold the shaver at a right angle to the skin so that the foils are touching the skin with equal pressure.
■Use moderate to slow, circular stroking movement.
■The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
■Do not press hard against the skin in order to avoid damage to the foils.
■Do not hold the shaver at an angle in which only one foil is touching the skin- this will distort the foil and may cause the cutters to damage the foil.
Rechargeable Battery
Removal
When your rechargeable shaver reaches the end of its useful life, the batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements. If this is not required by law, you may elect to dispose of the shaver without the batteries.
How to Remove the Rechargeable Batteries:
1. | Unplug the shaver. |
2. | Run the shaver until the motor |
| stops. |
3. | Remove the shaving head |
| cartridge. |
4. | Remove screws with a screw |
| driver. |
5. | Remove screws holding housing |
User Maintenance
CAUTION! Do not put in fire or muti- late your batteries when disposing as they may burst and release toxic
together. |
6. Pull the insert frame out of the |
casing. |
The
Replacing the Shaving Head Cartridge:
When your shaver’s cartridge replace- ment indicator begins to flash, it is time to replace the shaving head. The replacement part is model HGX-
In order to change the shaving head cartridge, simply push the eject button on the shaver and the cartridge will eject from the shaver. If a cartridge is ejected before the indicator light flash- es, the cartridge can be placed back onto the shaver until the hair pocket becomes full. When a new cartridge is installed, the replace indicator light will flash, confirming the
medium, 1 flash for light). The beard- type selector switch can be changed at any time up to the third shave, per cartridge. After the third shave, the selector switch will be locked until a new cartridge is installed.
Typically, a shaver with a medium beard type selected will take approximately 30 shaves to fill the hair collection cham- ber. The shaver will count a full shave if the shaver is on for at least one minute or more. The total number of shaves for each replacement cartridge will depend on what
Replacement Cartridge is model
To order shaver accessories call 800.736.4648, Visit
materials. Do not short circuit as it may cause burns. Dispose of prop- erly in accordance with your local and state requirements.
7. | Cut or break the wire straps on |
| both ends of the batteries, pry the |
| batteries from the foam adhesive |
| tape on the Circuit Board. |
8. | Dispose of batteries properly. |
8
9
8/30/07 12:02:21 PM