29565_800_IB_tri 8/24/06 3:21 PM Page 8
Usage Tips
Cleaning & Maintenance
Before using read the important safety instruction section in front of the manual.
Charging
Prior to using your shaver for the first time, put it on charge for 24 hours.
To charge your shaver:
■Make sure your shaver is turned off.
■Connect the cord to the shaver and then the charging adapter to the electric outlet. A charging indicator light will come on.
■Your shaver cannot be over- charged, so you can leave it plugged in and charging between shaves.
■Use only the charging adapter supplied with the shaver.
■Special feature allows you to run the shaver directly off the cord. Your shaver will not recharge while you are shaving, so after shaving directly from the cord, turn the unit off and set aside to charge.
■Provides up to two weeks worth of shaving after a one hour charge or a single shave after five minutes of charging.
NOTE: It may take up to 3 cycles for the battery to reach full capacity.
Model R-800
A blue indicator light shows charging. A red
Model R-825
A blue lighted fuel gauge displays the amount of charge remaining in 20% increments. When only 20% of the charge remains, the recharge red warning light illuminates.
Troubleshooting:
■If your
the shaver may not start when operated using the cord. If this condition occurs, charge the shaver for approximately five minutes before shaving.
■Your cord/cordless shaver should not be used strictly as a cord- operated shaver, as continued cord only use will result in reduction of battery life.
■In order to preserve the life of the batteries, they should be fully discharged every six months and then fully charged for 24 hours.
Cleaning your shaver
TO ASSURE OPTIMAL PERFORMANCE, IT IS RECOMMENDED THAT YOU CLEAN YOUR SHAVER AFTER EACH USE.
Detach the handheld unit from the power supply cord before cleaning. The cutting system of this shaver was designed to be cleaned by rinsing under warm running water or by brushing.
Cleaning your Remington® branded shaver is easy.
■ Open the hair pocket by pressing the release button and rotating
away from the
body of the shaver. You may blow out the stubble thoroughly, or rinse the shaver head in water. Rinse both sides of the head assembly.
■At Least Once a Week: For more complete cleaning, remove
the cutter retainer 
assembly from the 
hair pocket by turn- 
ing the center knob 
approximately 1/4 
turn counter clockwise. Hold cutter retainer assembly as shown, and remove head by turning approxi- mately 1/8 turn in the direction shown. Brush clean both the head and the cutter.
Reassemble head
to cutter retainer assembly by aligning and turning head 1/8
turn in the opposite direction. Repeat this
process for each of the 3 heads. Clean
each head and cutter 
set one at a time to 
prevent mixing cutter components. (These should be kept as sets). After cleaning, place cutter retainer assembly in the hair pocket, and secure by turning center knob approximately 1/4 turn clockwise.
Caution: Never put the shaver com- pletely under water. Do not use any aggressive cleansing agent as this may destroy the shaver coatings.
■To clean and lubricate your shaver’s cutters and head assembly, apply Remington® Shaver Saver®
Caution: Do not remove or replace the head assembly while shaver is running or plugged into an electrical outlet as it may cause damage to the unit’s cutters. The shaver shall not be used until it has dried.
■Worn or damaged parts should be replaced with Remington® branded replacement parts only.
8
9
