When is it time to replace your heads and cutters?

It is very important to replace your heads and cutters when necessary to insure a close,comfortable shave without irrita- tion. We recommend they be replaced every 12 months.Here are some signs of head and cutter wear, indicating that replacement is needed.

Irritation:

As the heads get excessively worn there may be some skin irri- tation.This would be especially noticed when applying After Shave lotion.

When the cutters wear you may feel a sense of “pulling”and a loss of closeness when you shave.This is an indication that it is time to replace your heads and cutters.

Easy-ViewTrimmer

Plastic Headguard

Brush

Trimmer

Button

Storage Pouch

Head & Cutter

Assembly

On/Off Button Locking Bar (Rechargeable Models only)

Charging

Indicator

(Green) All Models

except R-835

Low-Battery

Indicator (Red)

Shows When Shaver

Needs Charging

(R-850 Only)

Battery Removal

(Corded/Cordless and Cordless Rechargeable Models Only)

When your rechargeable shaver reaches the end of its useful life,the batteries must be removed from

the shaver and be recycled or disposed of properly in accordance with your local and state requirements.

The following procedures should be followed for battery removal:

Make sure your shaver is unplugged from any outlets,so you don’t risk an electrical shock.

Remove the Head Assembly by gently lifting the assembly away from the shaver.

Using a small Phillips head screwdriver, remove the screws from the upper and lower back

of the shaver.

Pull or gently pry the the shaver halves apart, exposing the battery.

Hold each battery in place and very carefully slide the clips from the terminals on each battery.

Lift or pry the battery out of the shaver.

CAUTION:THESE NICKEL-CADMIUM BATTERIES MUST BE RECYCLED OR DISPOSED IN ACCOR- DANCE WITH STATE AND LOCAL REGULA- TIONS.Do not burn or mutilate,as they may burst or release toxic materials.Do no short- circuit,as it may cause burns.

The EPA certified RBRC® Battery Recycling Seal on the nickel-cad- mium (Ni-Cd) battery indicates Remington is voluntarily participat- ing in an industry program to collect and recycle these batteries at the end of their useful life,when taken out of service in the United States or Canada.The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream,which may be illegal in your area. Please call 1-800-8-BATTERYfor information on Ni-Cd battery recycling and disposal bans/restriction in your area.Remington involvement in this program is part of our commitment to preserving our envi- ronment and conserving our natural resources.”

Page 3
Image 3
Remington R-850 important safety instructions When is it time to replace your heads and cutters?, Irritation