8 Chapter 4: Trimmer Operation

8 Chapter 4: Trimmer Operation

4.Measure out 30 feet of replacement line.

5.Push one end of the new line through the left line mounting hole on the spool (see Figure 4-13).

Direction of

Line Feed

6.Feed 15 feet of the line through this hole. Feed the other 15 feet of line through the right line mounting hole (see Figure 4-14). Pull the line tight (see Figure 4-15).

7.Lay the line from the left mounting hole into the upper spool section. Lay the line from the right mounting hole across the other line.Insert this line into the retaining slot between the upper and lower spool section, then lay the line into the lower spool section. See Figure 4-16 for proper line placement.

Figure 4-13: Inserting line in left hole

Direction of

Line Feed

Figure 4-14: Inserting line in right hole

Retaining

Slot

Figure 4-16: Arranging line into spool

Direction of

Line Feed

Figure 4-15: Pulling line tight

118336

Page 12
Image 12
Remington Power Tools ST3010A owner manual Trimmer Operation, Measure out 30 feet of replacement line