Renesas H8S2215R - page 11

• Ensure that ‘USER Program Mode’ is

selected.

• Confirm that ‘Use Default’ is selected.

• Press <Next>.

• Confirm the default selections of

‘Automatic’ and ‘Advanced’.

• Press <Next>.

• The following warning dialog will be

displayed.

• Press <OK>.

To communicate with the RSK FDT and HMon need to be able to change the operating mode of the microcontroller. To do this there are

settings to control the state of the Mode pins via the E8Direct interface. These settings are confirmed in the following screens.

Unless you are very sure that the mode pin settings need to change, do not modify the default settings.

11

Contents

Main REG10J0023-0100 RSK H8S2215R Tutorial Manual Renesas Starter Kit RENESAS SINGLE-CHIP MICROCOMPUTER Rev.1.00 Revision date 12.01.2007 www.renesas.com Table of Contents Chapter 1. Preface Chapter 2. Introduction Chapter 3. Tutorial Project Workspace Chapter 4. Project Workspace 4.1. Introduction 4.2. Creating a new Project Workspace 4.3. Build Configurations and Debug Sessions 4.3.1. Build Configuration 4.3.2. Debug Session Chapter 5. Building the Tutorial Project 5.1. Building Code 5.2. Connecting the debugger 5.3. Connecting to the target with E8Direct & HMon Page Page Page 5.3.1. Connecting To HMon Warning: Page Chapter 6. Downloading and Running the Tutorial Page Page Page Page Chapter 7. Project Files 7.1. Standard Project Files 7.1.1. Initialisation code (Resetprg.c / resetprg.h) Page 7.1.3. Main Tutorial Code (main.c / main.h) Chapter 8. Additional Information Page Renesas Starter Kit for H8S2215R Tutorial Manual