Renesas REG10J0083-0100

• Enter ID code as ‘0000E10A’.

• The Flash Memory write program is

downloaded.

• The Output window in HEW will state

‘Connected’

Now is a good time to save the HEW session.

• Select ‘File’ | ‘Save Session’.

If you have changed any workspace settings now is a good time to save the workspace.

• Select ‘File’ | ‘Save Workspace’.

Contents

Main REG10J0083-0100 Renesas Starter Kit for H8S/2472 Tutorial Manual RENESAS SINGLE-CHIP MICROCOMPUTER H8S FAMILY Rev.1.00 Revision date: 28.08.2008 www.renesas.com Table of Contents Chapter 1. Preface Chapter 2. Introduction Chapter 3.Tutorial Project Workspace Chapter 4. Project Workspace 4.1. Introduction 4.2. Creating a new Project Workspace 4.3. Build Configurations and Debug Sessions 4.3.1. Build Configuration 4.3.2. Debug Session Chapter 5. Building the Tutorial Project 5.1. Building Code 5.2. Connecting the debugger 5.3. Connecting to the target with the E10A Page Chapter 6. Downloading and Running the Tutorial Page Page Page Page Chapter 7. Project Files 7.1. Standard Project Files 7.1.1. Initialisation code (resetprg.c / resetprg.h) 7.1.2. Board initialisation code (hwsetup.c / hwsetup.h) 7.1.3. Main tutorial code (main.c / main.h) Chapter 8. Additional Information Page Renesas Starter Kit for H8S/2472 Tutorial Manual