Renesas REG10J0083-0100

the column to the left of the breakpoint column. Eight eventpoints can be set. Eventpoints do not require programming the

flash memory, and thus are faster to use.

• Press ‘Reset Go’ on the Debug Toolbar.

The code will execute to the breakpoint. At this point all the device initialisation will have been completed.

• Press ‘Step In’ on the Debug Toolbar.

The code window will open ‘main.c’ and show the new position of the program counter.

• Insert a breakpoint on the call to the ‘TimerADC’

function.

Contents

Main REG10J0083-0100 Renesas Starter Kit for H8S/2472 Tutorial Manual RENESAS SINGLE-CHIP MICROCOMPUTER H8S FAMILY Rev.1.00 Revision date: 28.08.2008 www.renesas.com Table of Contents Chapter 1. Preface Chapter 2. Introduction Chapter 3.Tutorial Project Workspace Chapter 4. Project Workspace 4.1. Introduction 4.2. Creating a new Project Workspace 4.3. Build Configurations and Debug Sessions 4.3.1. Build Configuration 4.3.2. Debug Session Chapter 5. Building the Tutorial Project 5.1. Building Code 5.2. Connecting the debugger 5.3. Connecting to the target with the E10A Page Chapter 6. Downloading and Running the Tutorial Page Page Page Page Chapter 7. Project Files 7.1. Standard Project Files 7.1.1. Initialisation code (resetprg.c / resetprg.h) 7.1.2. Board initialisation code (hwsetup.c / hwsetup.h) 7.1.3. Main tutorial code (main.c / main.h) Chapter 8. Additional Information Page Renesas Starter Kit for H8S/2472 Tutorial Manual