M208 Re:control
B-1
B TUNER Synchronising tuner stations
The following display appears the
first time the Tuner is started on
the remote control:
This indicates that the Tuner
stations are not yet synchronised.
It is possible to operate the remote
control using the CH +/- and/or the
numeric keypad. Tuner operation
is however much more comfor-
table if the M51 Tuner stations
have been synchronised with the
M208.
To do this, you should connect the
M208 to the M208 Link interface
with the USB cable supplied. The
Link interface for its part is
connected to the M51 through a
cable to the M Link.
see Synchronisation plan
in Chapter A-8.
Once the connection is estab-
lished, switch on the M51 and
select the TUNER at the M208
and press the SETUP button.
Confirm the Synchronize
setting with the OK button.
Important advice
Neither the M51 nor the M208 can
be operated while the
synchronisation is running.
Synchronisation now starts and
takes a few seconds. When the
synchronisation is complete, the
following display appears:
The next time you call the Tuner,
all tuner stations stored in the M51
appear on the display. The display
order is determined by the order
they were stored in the M51.
L
If you modify the tuner stations in
the M51 by adding, deleting,
renaming or moving entries, you
should carry out another
synchronisation with the M208.
Otherwise, you will call wrong
tuner stations.