Rheem Advantage Plus AdvantagePlusfrom Rheem-Ruud, The sealed-combustion gas fired water heater

AdvantagePlus™from Rheem-Ruud

The sealed-combustion gas fired water heater

line that’s perfect for commercial applications needing LARGE VOLUMES of LOW-COSThot water.

•95% efficient sealed-combustion design: Saves hundreds, even thousands, of dollars in annual operating costs.

•No chimney required – Vents up to 40 feet using 3" Schedule 40 PVC, CPVC or ABS pipe.*

*100,000 and 130,000 BTU/hour models are certified to vent with 2˝ Schedule PVC, CPVC or ABS Pipe.

•Low-weightdesign:Rust-proof nonferrous outer jacket and nonmetallic trim components make AdvantagePlus much lighter and easier to maneuver than comparable competitive models.

•Rugged and corrosion-resistant 316L stainless steel tank ensures long life. No anode rod is needed.

•High-efficiency 90/10 cupronickel heat exchanger features the same highly durable, corrosion-resistant material commonly used for boiler heat exchangers.

•Whisper-quiet design: The burner and blower assembly is located below eye level and behind an enclosure made of ABS plastic, resulting in an ultra-quiet operation.

•Easy to service: All components and controls are conveniently located behind an easy-to-remove, front- mounted access panel.

•Storage capacities from 45 to 119 gallons.

•Inputs from 100,000 to 199,000 BTU/hour.

•Large volumes fast: 119-gallon, 199,000 BTU/hour model delivers 314 gallons of hot water in the first hour, while needing only 31 minutes to fully recover.

•Saves energy: No burning pilot light.

•Meets low NOx requirements in California (SCAQMD Rule 1146.2) and Texas(TNRCC).

•No chimney required: 85 equivalent feet of vent length, using plastic pipe.

•Self-diagnostic electronic control: Features digital readout of water temperature set point and differential.

•Minimizes heat loss: 2" polyurethane foam insulation shrinks heat loss to less than 0.5° F per hour (R-17 rating).

•Wide temperature-setting range: 70°F to 160°F. (180°F on booster models).

•Zero clearance to any combustible surface.

•Easy equipment servicing through highly accessible front cover (24" service clearance recommended).

The ultimate in heavy-duty durability, high-tech efficiency and user-friendly flexibility.

Heat Exchanger/

Combustion Chamber

Control Well and E.C.O.

Air Inlet Connector

Gas Valve

Combustion Blower

Gas Burner

Gas Inlet Nipple 1/2”

Hot Surface Ignitor

Flame Probe

Exhaust Outlet Connector

Control Board

Vent Over-Temp

Reset Switch

Exhaust Elbow and Drain

Pressure Switch

Transformer

Condensate Connector Hose

Condensate Connector