Rheem GAS DOMESTIC OUTDOOR WATER HEATER

INSTALLATION

These conditions may result in either water at a temperature exceeding the

requirements of AS/NZS 3500.4 being delivered to the hot water outlets in the

ablution areas, or the device closing completely and not delivering water at all,

or the device failing. Under either condition, the operation and performance of

the device cannot be guaranteed.

Circulated Hot Water Flow and Return System – Gas Water Heater

REDUCING HEAT LOSSES

The cold water line to and the hot water line from the water heater must be

insulated in accordance with the requirements of AS/NZS 3500.4. The

insulation must be weatherproof and UV resistant if exposed.

ANODE TYPES

The correct anode type for the water supply being used must be fitted in the

water heater (refer to “Water Supplies” on page 30). The black anode is fitted

as standard.

Total Dissolved Solids in water supply to the water heater Anode colour code

0 – 40 mg/L Green

40 – 600 mg/L Black

600 – 2500 mg/L Blue