Riccar 4000 manual Handle Adjustments, Replacing Filter Bag, Assembly And Operation

ASSEMBLY AND OPERATION

Fig. 7

Fig. 8

Fig. 9

Fig. 10 Fig. 11

HANDLE ADJUSTMENTS

The handle can be set to one of three positions: Upright, Middle or Low. To release the handle, step on the pedal at the left rear cor- ner of the vacuum cleaner [Fig. 7].

1.UprightPosition: Handle locks in this position for vacuum cleaner storage [Fig. 7]. The handle should always be in the upright position when cleaning tools are used.

2.Middle Position: This position is for normal cleaning [Fig. 8]. While in the middle position, the front of the nozzle can be raised for crossing room thresholds by lowering the handle.

3.Low Position: This position is used for cleaning under furniture [Fig. 9].

REPLACING FILTER BAG

Genuine Riccar® EcoPure® Vacuum Cleaner filter bags should be used for best performance and air filtration. Always operate the vacuum cleaner with a filter bag installed.

NOTE: If secondary or post filters need to be replaced, see page 6 before replacing filter bag.

1.Remove the used filter bag by pulling bag collar off the bag holder [Fig. 10]. Do not re-use filled filter bags.

2.Attach the new filter bag onto the bag holder.

3.Re-insert the tab on bottom edge of dust cover into the groove on the dust compartment housing [Fig. 11]. Press it into place and close the dust cover tightly.

5