130
Troubleshooting

Refer to the pointers listed below before submitting the equipment for repairs. If

the problem persists after trying the suggestions, contact your nearest Ricoh

service office.

Power Source

Problem
Power will not
come on
Power cuts out
Battery will not
charge
Battery quickly
consumed
Cause
Battery not loaded or battery
exhausted
AC adapter not properly connected
No operation performed so auto
power off function was activated
Battery exhausted
Battery at end of service life
Camera operated in extremely high
or low temperature environment
Camera operated in dark
environment requiring frequent use
of flash
Remedy
Insert battery correctly or charge battery.
Connect correctly.
Switch camera on again.
Charge battery.
Replace with new battery.
Page
P.15
P.16
P.18
P.24
P.15
P.16

Recording and Playback

Problem
Cannot confirm
shot image
No image on
LCD monitor
Cause
Battery not loaded or battery
exhausted
No power, or mode dial not set
Shutter release button not fully
pressed (pressed halfway)
CF card or PC card not formatted
No memory space on CF card or PC
card
No space in internal memory
CF card or PC card at end of
service life
Self-timer on
Flash charging
CF card or PC card contact surface
dirty
LCD confirmation time too short
No power or LCD monitor is dark
Video system is set on PAL and
video cable is still plugged in.
Remedy
Insert battery correctly or charge battery.
Switch on and set mode dial to recording
mode.
Press shutter release button all the way.
Format card.
Delete unnecessary files or insert new card.
Delete unnecessary files.
Insert new card.
Press to disengage self-timer mode.
Wait until flash LED stops blinking.
Clean with soft dry cloth.
Increase LCD confirmation time.
Switch on and press DISPLAY button to
display image on LCD monitor, or adjust
monitor contrast using LCD contrast
adjustment buttons.
Set video system to NTSC or disconnect
video cable.
Page
P.15
P.16
P.25
P.55
P.43
P.20
P.112
P.112
P.20
P.67
P.56
P.120
P.28
P.49
P.87
P.88
P.119
Shutter release
button pressed
but no image
recorded