Error Messages
If an error message is displayed on the LCD monitor or LCD panel, follow the procedures below.
Error Message | Remedy |
|
|
System error occurs | Turn the power off and on. |
|
|
Unable to change memory | Storage memory can not be switched due to some reason. Check | ||
| content of storage memory or format storage memory. | ||
Insufficient memory | Erase unwanted files or format to obtain sufficient memory space. | ||
Change to card | Change the storage memory to card by using |
| . |
| |||
|
|
|
|
Format required | Format of selected storage memory damaged. Format storage | ||
| memory. |
|
|
Format internal memory | Internal memory damaged. Format it by pressing shutter release | ||
| button. |
|
|
Card is unavailable | Card damaged. Format. |
|
|
Format error | Format again. If formatting is not completed, memory error | ||
| occurs. Avoid using the storage memory. |
|
|
UNMATCHED FILE | Unplayable file was selected. |
|
|
No file | No recorded files in specified folder. Change folder or select | ||
| storage memory that contains files. |
|
|
Insufficient memory. Continue copy? | Exceeded memory capacity. Perform one of following and copy | ||
| again: |
|
|
| • Delete unnecessary copy source, |
|
|
| • Delete unnecessary files in destination, or |
|
|
| • Format storage memory. |
|
|
File number over. Cannot save. | File number exceeded limit. Delete unnecessary files or use | ||
| another memory card. |
|
|
Exceeded DPOF limit. Set up to 999. | Number of index print or number of specified print exceeded limit. | ||
| Reset DPOF settings of some files. |
|
|
Failed to create DPOF files | DPOF settings cannot be saved. Delete unnecessary files before | ||
| repeating operation. If message still appears, memory may be | ||
| damaged. Make a backup file of files saved in memory and | ||
| format memory. |
|
|
Failed to read DPOF files | DPOF settings are unreadable. Reset all DPOF settings before | ||
| repeating operation. If message still appears, memory may be | ||
| damaged. Make a backup file of files saved in madia and format | ||
| memory. |
|
|
Note • If the error message continues to be displayed after the above procedures have been followed, open the terminal cover and press the reset switch (P.6) with the tip of a propelling pencil or similar object. The settings will return to the factory default settings.
If the error message is still displayed, contact the store where purchased or your nearest Ricoh service office.
Appendix
