5.Eject button

This is the button used to eject or insert in the disc tray.

6.Emergency eject hole

This drive has a function that allows the disc to be ejected manually if this becomes necessary in an emergency such as failure of the drive or a power outage.

Caution

This feature is a last measure to be used only in an emergency. Using it excessively will cause malfunction.

Rear panel

1.Digital Audio Output Connector

Provides output to a sound card (Digital signal).

2.Analog Audio Output Connector

Provides output to a sound card (Analog signal).

3.Jumper Connector

This jumper determines whether the drive is configured as a master or slave. Changing the master-slave configuration takes effect after power-on reset.

4.IDE Interface Connector

Connect to the IDE (Integrated Device Electronics) interface using a 40-pin flat IDE cable.

Do not connect or disconnect the cable when the power is on, as this could cause a short circuit and damage the system. Always turn the power OFF when connecting or disconnecting the cable.