OPERATORS MANUAL

MODELS 2032-OS, 2048-OS, 204830-OS, 3068-OS

RIDGID ON-SITE STORAGE EQUIPMENT

DANGER

Do NOT put fuels, flammables, explosives or hazardous materials inside these products.

Gasoline, solvents, gun powder or other munitions, dynamite, propane, acetylene or other such products can explode if stored inside these products.

Use these products ONLY for storing and transporting electric or hand tools and equipment, and other similar materials.

Failure to follow these warnings or modifications or other uses of these products could result in death, seri- ous injury or property damage.

WARNING

For Models 2048-OS and 204830-OS:

To prevent electric shock, explosion, fire and/or serious personal injury when using storage chest with:

Extension Cord -

Follow all Extension Cord manufacturer’s Warnings and Instructions.

After removing knock-out, insert Rapid Pass™ rubber grommet. Do NOT insert extension cord through hole without grommet in place (see figure 8, on page 3).

Only use a three-wire extension cord with all three prongs intact. Never remove the round grounding prong.

Extension cord must be connected to a 120 Volt GFCI protected outlet with proper ground. If GFCI outlet is not available, use an extension cord with GFCI protection built in.

Check the insulation and plugs of extension cord before using. Do NOT use cord if it is worn or damaged.

Do NOT overload extension cord.

Remove extension cord from the Rapid Pass™ hole before moving or transporting storage chest.

Only use an extension cord that is rated for outdoor use.

Do NOT connect extension cord to outlet that also sup- plies critical safety equipment with power.

Cordless Power Tool Battery Chargers -

See Charger’s Owner’s Manual for proper use and care of charger and batteries. Follow all Warnings and Instructions provided with your battery charger.

Place chargers and electrical connections in tray.

Chargers are Dry location use only. Do NOT expose to liquid, vapor, or rain. Should your charger become wet, Do NOT attempt to use. Unplug extension cord from supply before handling wet charger or cords.

Only use chargers and batteries that are intact and oper- ating properly.

Do NOT touch metal prongs when plugging charger into extension cord.

Keep flammable materials like paper or rags away from charger, cords or connections.

Do NOT place or attempt to charge lead acid, car type batteries in storage chest.

WARNING

Keep hands clear when closing lid. Failure to do so could result in severe injury.

–ATTENTION–

Read and understand all instructions and warnings before operating or using this product.

–NOTICE–

Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries to persons or

property resulting from any modification to, or unintended use of this product.

Page 1
Image 1
RIDGID 2032-OS, 2048-OS, 3068-OS, 204830-OS owner manual Operators Manual