RIDGID OS and 204830-OS FLEXI-SHELF Instructions, For Removing the Shelf from BOX, Side View

2048-OS AND 204830-OS FLEXI-SHELF™ INSTRUCTIONS

FOR REMOVING THE SHELF FROM BOX

1.	Be sure all contents are removed from
	shelf.
2.	Securely grasp shelf at the right side (fac-
Figure 7	ing box) with both hands and gently lift
	(figure 7).
3.	Remove from box and store properly.

ADJUSTING THE FLEXI-SHELF™ FOR YOUR STORAGE NEEDS

To adjust dividers:

HAND TOOL STORAGE

SCREWDRIVER

STOP TAB

Figure 8

1.Gently lift dividers straight up while holding down shelf with other hand.

2.Remove divider to desired storage location and reverse procedure (figure 8).

Securing shelf for transport:

1.To minimize movement during transport, make sure the shelf front is located behind the stop tabs on each side of the box.

2.Once the box is on-site the shelf can be moved for- ward by slightly lifting the front edges over the stop tabs. The shelf bottom should always lie flat on the runners when finished adjusting the shelf.

TO INSTALL RAPID PASS™ GROMMET (Model 2048-OS and Model 204830-OS)

SIDE VIEW

Figure 9

TOOLS REQUIRED- Hammer and flat blade screwdriver.

1.Locate the “knockout” on the upper right (facing box) corner of the rear box panel.

2.With a screwdriver and hammer, carefully punch out the “knockout” from the inside of the box so that metal ring will fall outside box (figure 9).

3.Place the rubber “Rapid Pass”™ grommet from the inside of the box in the hole and be sure that it is properly seated. BE SURE NO SHARP METAL EDGES ARE EXPOSED (figure 10).

4.When passing cords into the box, be sure to always enter box from the rear. After head of cord is in place, slightly pull back 2-3” to ensure weather resistant “star bursts” are facing toward the outside of box (fig- ure 11). Never push the cord from inside the box so that mating plug points are exposed to the environment

5.BE SURE TO FOLLOW ALL ELECTRICAL SAFETY PRECAUTIONS.

Figure 10

Figure 11

EXTERIOR

VIEW

3