t^okfkdW For your own safety, turn switch “OFF” and remove plug from power source outlet before removing insert.
1.Unplug the saw.
2.Remove the blade guard, the saw blade insert, and the saw blade.
3. To remove insert: | cä~íÜÉ~Ç=pÅêÉï |
| |
a. Make sure saw is off and unplugged. |
|
b. Loosen flathead screw. |
|
c. Lift insert from front end, and pull |
|
toward front of saw. |
|
|
|
t^okfkdW= To reduce the risk of injury from accidental start, make sure switch is “OFF” and plug is not con- nected to power source outlet.
1.Insert should be flush with table top. Check as shown. Loosen flathead screw that holds insert and adjust the four set screws as necessary. Tighten flathead screw. Do not tighten screw to the point where it bends the insert.
t^okfkdW=Insert must be even with the table surface. Inserts too high or low can let the workpiece “snag” or catch on uneven edges. Workpiece could twist and kick back and could result in serious personal injury.
rëÉ=pÉí=pÅêÉï=têÉåÅÜ
cìêåáëÜÉÇ=ïáíÜ=p~ï
2.Remove the dado/molding insert and install the dado or molding head...
replace the insert.
rëáåÖ=íÜÉ=a~Çç=~åÇ=jçäÇáåÖ=fåëÉêí
klqbW=Do not install the outer loose collar (the one next to the arbor nut) when installing the dado or the dado set or molding head.
1.Before using the dado or the molding head...or the insert, read and under- stand the Safety and Operating instruc- tions contained in the Operator’s
Manual furnished with your table saw and the instructions furnished with your dado head or molding head.
2.The dado or molding head can be used with the saw arbor tilted BUT NOT IN ALL POSITIONS... NEVER TILT THE ARBOR WHILE THE SAW IS RUN- NING.
4
