NPK pÉÅìêÉ=tçêâ
Use clamps or a vise to hold work when practical. It’s safer than using your hand, frees both hands to oper- ate tool.
NQK açåÛí=lîÉêêÉ~ÅÜ
Keep proper footing and balance at all times.
NRK j~áåí~áå=qççäë=táíÜ=`~êÉ
Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and chang- ing accessories.
NSK aáëÅçååÉÅí=qççäë
Before servicing; when changing accessories such as blades, bits, cut- ters, etc.
NTK qç=oÉÇìÅÉ=qÜÉ=oáëâ=lÑ=^ÅÅáÇÉåí~ä= pí~êíáåÖ=
Make sure switch is in “OFF” position before plugging in. Turn switch “OFF” in the event of a power failure.
NUK rëÉ=oÉÅçããÉåÇÉÇ=^ÅÅÉëëçêáÉë
Consult the operator’s manual for rec- ommended accessories. Follow the instructions that accompany the accessories. The use of improper accessories may cause hazards.
NVK kÉîÉê=pí~åÇ=lå=qççä
Serious injury could occur if the tool is tipped or if the cutting tool is acciden- tally contacted.
Do not store material above or near the tool such that it is necessary to stand on the tool to reach them.
OMK `ÜÉÅâ=a~ã~ÖÉÇ=m~êíë
Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function. Check for align- ment of moving parts, binding of mov- ing parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced. If power cord is worn or cut, or dam- aged in any way, have it replaced immediately.
ONK aáêÉÅíáçå=lÑ=cÉÉÇ
Feed work into a blade or cutter against the direction of rotation of the blade or cutter only.
OOK kÉîÉê=iÉ~îÉ=qççä=oìååáåÖ=rå~íJ íÉåÇÉÇK
Turn power off. Don’t leave tool until it comes to a complete stop.
3
